![]() ![]() ![]() The configuration of these protocols is shown in Session 15. A username and password, however, will be required to gain access to the configuration options. The serial connection, therefore, will no longer be needed as the router will now be accessed via its IP address. Whilst connected to the device a remote connection method should be set up, more likely Telnet or SSH. During the initial configuration of a device, or if the device is not accessible over the network, you will need to use a console connection. To connect to a device through the CLI you will need to use one of the following methods depending on the current status of the device. It is part of the Cisco Internetwork Operating System or IOS for short. The majority of manufacturers use the same principles in their own CLIs with slight variations on commands. With Cisco commercial networking equipment, the configuration is done via a CLI instead. ![]() By default, a Cisco device will not have a web page for configuration. In Session 1 we looked at connecting to a home gateway this was done with a GUI interface via a web page. In this part we will look at how to access the Cisco command-line interface. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |